Genetec - Using the auto-run command with Hanwha Vision units in Security Desk

If you configure the auto-run settings on the unit's web page, such as the auto-run mode (Swing, Group, Tour, Trace, Auto pan, and so on) and the auto-run parameters, those settings are used by default in Security Center when you add the unit in Config Tool.

1. From the Video task in Config Tool, select the camera to configure.
2. Click the Hardware tab.
3. From the Auto run mode drop-down list, select one of the following auto-run modes:

   Auto pan

   Rotate the PTZ 360 degrees according to the configured speed and tilt.

   Home

   Move the PTZ motor to the home preset position.

   Pattern

   Play the PTZ pattern that was configured. This is called the Trace mode on the unit's web page.

   Preset

   Move the PTZ motor to the preset position that was configured.

   Preset tour

   Perform a list of configured presets. This is called the Group mode on the unit's web page.

   Schedule

   Perform an auto-run command according to the configured schedule.

   Swing

   Move the PTZ motor between two presets, according to the configured speed, dwell time, and swing mode (pan, tilt, or pan and tilt).

   Tour

   Execute a list of configured preset tours.

4. Configure the parameters for the auto-run mode you selected.
   For information about the auto-run mode parameters, see your Hanwha Vision documentation.
5. To start the auto-run command in Security Desk, do the following:
   1. In Security Desk, select the PTZ camera in a canvas tile.
   2. In the PTZ widget, click Specific commands
   3. In the Specific commands dialog box, click Enable auto run and click Execute command.

   4. To stop the auto-run command, click Disable auto run.

   5. Click Close.