Zenitel: Device Configuration

Applies to: All Zenitel Intercoms

Summary

After updating the firmware in Zenitel, program the functionality of the Zenitel device. This article explains button and relay configuration. 

Button Configuration

To configure the button:

1. From the Main page of the device UI, select the Advanced Configuration checkbox.
   
   
   
   
2. Select the Main Settings tab.
   
   
3. Uncheck Read IP Address.
   
   
4. Click SAVE.
   
   
5. Select the Edge Configuration tab to reach the Edge Configuration settings.
   
   
   
   
6. Select the RTSP and ONVIF tab.
   
   
7. Select the Report DAK as Digital Input in ONVIF checkbox.
   
   
8. Click SAVE.

Relay Configuration

To configure the relay: 

1. Select Edge Configuration > RTSP and ONVIF.
   
   
   
   
2. Uncheck Enable control of relay IDLE state.
   
   
3. Click SAVE.